Chrysler 2005 Crossfire SRT6 Service Manual page 960

8J - 6 INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS
LAMP OUTAGE INDICATOR CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the ignition on.
• Set Condition: Lamp Outage Indicator circuit failure between the Illumination Control Module and the Instru-
ment Cluster.
INDICATOR CIRCUIT OPEN
INDICATOR LAMP
ILLUMINATION CONTROL MODULE
INSTRUMENT CLUSTER
For a complete Instrument Cluster Circuit Diagram, (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
THE LAMP OUTAGE INDICATOR LAMP/INSTRUMENT CLUSTER
Turn the ignition off.
Disconnect the Instrument Cluster C1 harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Lamp Outage Indicator circuit at the Instru-
ment Cluster C1 harness connector.
Is the voltage above 10 volts?
Yes >> Inspect the Lamp Outage Indicator Lamp. If OK, replace
the Instrument Cluster.(Refer to 8 - ELECTRICAL/IN-
STRUMENT CLUSTER - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
POSSIBLE CAUSES
ZH