Chrysler 2005 Crossfire SRT6 Service Manual page 1375

ZH
PASSENGER SEAT BELT TENSIONER SQUIB CIRCUIT (CONTINUED)
3.
MEASURE THE RESISTANCE OF THE PASSENGER SEAT BELT SQUIB LINE 1 CIRCUIT
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the ORC harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect the appropriate harness adapter to the ORC connector.
Disconnect the Load Tool from the Passenger Seat Belt Tensioner
Squib connector.
Measure the resistance of the Passenger Seat Belt Squib Line 1 cir-
cuit from the ORC connector to the Passenger Seat Belt Tensioner
Squib connector.
Is the resistance below 1.0 ohm?
Yes >> Go to 4
No >> Repair the Passenger Seat Belt Squib Line 1 circuit for an
open.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
4.
MEASURE THE RESISTANCE OF THE PASSENGER SEAT BELT SQUIB LINE 2 CIRCUIT
With the ignition off.
Measure the resistance of the Passenger Seat Belt Squib Line 2 cir-
cuit from the ORC connector to the Passenger Seat Belt Tensioner
Squib connector.
Is the resistance below 1.0 ohm?
Yes >> Go to 5
No >> Repair the Passenger Seat Belt Squib Line 2 circuit for an
open.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 19