Chrysler 2005 Crossfire SRT6 Service Manual page 1047

ZH
15. Seat Belt Indicator Lamp The Seat belt indicator
lamp illuminates if the driver's seat belt is not
buckled.
16. Turn Signal Indicator Lamp The Turn signal indi-
cator lamps (1), located in the upper portion of the
speedometer on the right and left of the ESP indi-
cator, illuminate when either the right or left turn
signal is activated by the multifunction switch on
the steering column. Both lamps will illuminate
when the Emergency Flasher switch has been
activated.
The cluster gives audible tone signals to notify the driver to take the following actions:
Note: With the key removed and the door open, the audible tone sounds if the headlamps or parking lamps
are on. Operation of the standing lamps, which are intended for use when the vehicle is unoccupied, will
not trigger this warning.
• Release the parking brake
• Switch off headlamps.
• Remove the key from the ignition.
Turn signal indicator ticking, activating the turn signal switch is indicated audibly by the turn signal indicator tick-
ing. The driver's attention is brought to a problem in the turn signal system by the turn signal indicator ticking at a
higher frequency. The turn signal indicator ticking is generated electromagnetically. The frequency corresponds to
that of the turn signal indicator lamp.
Parking Brake-on reminder, an audible sound is emitted via a small speaker whenever the cluster detects the
parking brake switch is in the ON position at a speed of 5 km/h (3 MPH) or more.
Headlamps-on reminder, the Headlamps-on reminder sounds when the headlamp switch is in the ON position, the
ignition key is removed from the ignition, and the driver's door is open.
INSTRUMENT CLUSTER - SERVICE INFORMATION 8J - 93