Chrysler 2005 Crossfire SRT6 Service Manual page 1090

8L - 24 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*LEFT HIGH BEAM HEADLAMP INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT OPEN
GROUND CIRCUIT OPEN
LEFT HIGH BEAM HEADLAMP BULB
For a complete Exterior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR -
SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE LEFT HIGH BEAM HEADLAMP BULB
Note: Inspect Fuse 5 located in the Illumination Control Module/IP Fuse Block. If the fuse is open, repair the
cause of the open fuse before continuing.
Turn the ignition off.
Remove the Left High Beam Headlamp bulb and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the Left High Beam Headlamp bulb. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERI-
OR/HEADLAMP - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE FUSED B(+) CIRCUIT RESISTANCE
Disconnect the Left Front Lamp Assembly harness connector.
Disconnect the Illumination Control Module harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between the Left Front Lamp Assembly har-
ness connector cavity 4 and the Illumination Control Module harness
connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open between the Left
Front Lamp Assembly and the Illumination Control Module.
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH