Chrysler 2005 Crossfire SRT6 Service Manual page 1584

8R - 14 WIPERS/WASHERS - ELECTRICAL DIAGNOSTICS
*WIPERS INOPERATIVE (CONTINUED)
MULTI-FUNCTION SWITCH
WIPER SWITCH MUX CIRCUIT OPEN
BODY CONTROL MODULE
WIPER MOTOR
For a complete Wipers/Washers Circuit Diagram, (Refer to 8 - ELECTRICAL/WIPERS/WASHERS - SCHEMATICS
AND DIAGRAMS).
1.
TEST THE WIPER MOTOR
Turn the ignition off.
Disconnect the Body Control Module (BCM) C2 harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 1 of the BCM C2 harness con-
nector and B(+).
Connect a jumper wire between cavity 41 of the BCM C2 harness con-
nector and ground.
With the jumper wires connected, does the Wiper Motor move?
Yes >> Go to 2
No >> Replace the Wiper Motor. (Refer to 8 - ELECTRICAL/WIP-
ERS/WASHERS/FRONT WIPER MOTOR - REMOVAL)
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH