Chrysler 2005 Crossfire SRT6 Service Manual page 1475

ZH
5. Reposition the carpet to the floor.
Note: The carpet is firmly molded, and will need to
be properly seated to the contours of the vehicle
floor.
6. Install the carpet hold down button (3).
7. Install the front seat.
8. Reconnect the power seat harness connectors.
9. Install the seat belt bolt (2). Tighten the seat belt
bolt to 35 N·m (26 ft. lbs.).
10. Install the seat track rear bolts (1). Tighten the
rear bolts to 50 N·m (37 ft. lbs.).
11. Temporarily reconnect the negative battery cable.
12. Move the seat to the full rearward position.
13. Disconnect the negative battery cable again.
14. Install the seat track front bolts (1). Tighten the
front bolts to 50 N·m (37 ft. lbs.).
RESTRAINTS - SERVICE INFORMATION 8O - 119