Chrysler 2005 Crossfire SRT6 Service Manual page 1592

8R - 22 WIPERS/WASHERS - ELECTRICAL DIAGNOSTICS
*WIPERS LOW SPEED INOPERATIVE (CONTINUED)
2.
MEASURE WIPER SWITCH MUX CIRCUIT VOLTAGE
Disconnect the BCM harness connector.
Turn the ignition on.
Measure the BCM C3 harness connector cavity 65 for voltage with the
Wiper Switch in the Low position.
Is the voltage approximately 12 volts?
Yes >> Replace the Body Control Module. (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Replace the Multi-Function Switch. (Refer to 8 - ELECTRI-
CAL/LAMPS/LIGHTING - EXTERIOR/MULTI-FUNCTION
SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
ZH