Chrysler 2005 Crossfire SRT6 Service Manual page 970

8J - 16 INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS
AMBIENT TEMPERATURE SENSOR CIRCUIT (CONTINUED)
9.
MEASURE THE RESISTANCE BETWEEN GROUND AND THE AMBIENT TEMPERATURE SENSOR
SIGNAL CIRCUIT
Turn the ignition off.
Disconnect the Instrument Cluster harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Ambient Temperature
Signal circuit.
Is the resistance below 1000.0 ohms?
Yes >> Repair the Ambient Temperature Sensor Signal circuit for
a short to ground.
Perform BODY VERIFICATION TEST.
No >> Go to 10
10.
MEASURE THE RESISTANCE FROM THE AMBIENT TEMPERATURE SENSOR SIGNAL CIRCUIT TO
THE SENSOR GROUND CIRCUIT
With the ignition off.
Measure the resistance from the Ambient Temperature Sensor Signal
circuit to the Sensor Ground circuit at the Ambient Temperature Sen-
sor connector.
Is the resistance below 1000.0 ohms?
Yes >> Repair the Ambient Temperature Sensor Signal circuit for
a short to the Sensor Ground circuit.
Perform BODY VERIFICATION TEST.
No >> Replace the Instrument Cluster. (Refer to 8 - ELECTRI-
CAL/INSTRUMENT CLUSTER - REMOVAL).
Perform BODY VERIFICATION TEST.
ZH