Chrysler 2005 Crossfire SRT6 Service Manual page 1096

8L - 30 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*RIGHT HIGH BEAM HEADLAMP INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT OPEN
GROUND CIRCUIT OPEN
RIGHT HIGH BEAM HEADLAMP BULB
For a complete Exterior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR -
SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE RIGHT HIGH BEAM HEADLAMP BULB
Note: If both the right high beam headlamp and the high beam indicator are inoperative, inspect Fuse 3
located in the Illumination Control Module/IP Fuse Block. If the fuse is open, repair the cause of the open
fuse before continuing.
Turn the ignition off.
Remove the Right High Beam Headlamp bulb and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the Right High Beam Headlamp bulb. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTE-
RIOR/HEADLAMP - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE FUSED B(+) CIRCUIT RESISTANCE
Disconnect the Right Front Lamp Assembly harness connector.
Disconnect the Illumination Control Module harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between the Right Front Lamp Assembly har-
ness connector cavity 4 and the Illumination Control Module harness
connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open between the
Right Front Lamp Assembly and the Illumination Control
Module.
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH