Chrysler 2005 Crossfire SRT6 Service Manual page 1309

ZH
*BOTH POWER SEATS INOPERATIVE (CONTINUED)
POWER SEAT RELAY FUSED B(+) CIRCUIT OPEN
POWER SEAT RELAY GROUND CIRCUIT OPEN
POWER SEAT RELAY
For a complete Power Seats Circuit Diagram, (Refer to 8 - ELECTRICAL/POWER SEATS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
TEST THE POWER SEAT RELAY CIRCUIT
Note: Inspect Fuses 21 and 22 located in the Underhood Accessory Fuse Block. If the fuses are open, repair
the cause of the open fuse before continuing.
Turn the ignition off.
Disconnect the Power Seat Relay.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 8 and cavity 2 of the Power
Seat Relay harness connector.
Actuate the Driver and Passenger Power Seat Switches.
Did the Driver and Passenger Power Seats move?
Yes >> Replace the Power Seat Relay.
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE POWER SEAT RELAY FUSED B(+) CIRCUIT VOLTAGE
Disconnect the jumper wire.
Measure the voltage of the Fused B(+) circuit at the Power Seat Relay
harness connector.
Is the voltage above 10 volts?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open.
Perform BODY VERIFICATION TEST.
POWER SEATS - ELECTRICAL DIAGNOSTICS 8N - 79
POSSIBLE CAUSES