Chrysler 2005 Crossfire SRT6 Service Manual page 1359

ZH
ORC INTERNAL FAILURE (CONTINUED)
When Monitored and Set Condition
• When Monitored: Ignition on.
• Set Condition: If the Occupant Restraint Controller (ORC) detects an internal malfunction, the DTC is set.
FUSED IGNITION SWITCH OUTPUT CIRCUIT
OCCUPANT RESTRAINT CONTROLLER
For a complete Restraints System Circuit Diagram, (Refer to 8 - ELECTRICAL/RESTRAINTS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
MEASURE THE VOLTAGE OF THE ORC FUSED IGNITION SWITCH OUTPUT CIRCUIT
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the ORC harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused Ignition Switch Output circuit at the
ORC harness connector.
Is the voltage above 10 volts?
Yes >> Replace the Occupant Restraint Controller. (Refer to 8 -
ELECTRICAL/RESTRAINTS/OCCUPANT
CONTROLLER - REMOVAL).
WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS DROPPED AT ANY TIME, IT MUST BE
REPLACED.
Perform AIRBAG VERIFICATION TEST.
No >> System voltage must be between 12 and 16 volts. Repair the voltage concern as necessary.
Perform AIRBAG VERIFICATION TEST.
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 3
POSSIBLE CAUSES
RESTRAINT