Chrysler 2005 Crossfire SRT6 Service Manual page 1094

8L - 28 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*RIGHT LOW BEAM HEADLAMP INOPERATIVE (CONTINUED)
3.
MEASURE RIGHT LOW BEAM HEADLAMP VOLTAGE
Connect the Illumination Control Module harness connector.
Turn the ignition on.
Turn the low beam headlamps on.
Measure the voltage between the Right Front Lamp Assembly harness
connector cavity 3 and ground.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Replace the Illumination Control Module. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
LAMP SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
4.
MEASURE RIGHT LOW BEAM HEADLAMP GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Turn the low beam headlamps off.
Measure the resistance between the Right Front Lamp Assembly har-
ness connector cavity 2 and ground.
Is the resistance below 5.0 ohms?
Yes >> Ensure that the Right Low Beam Headlamp bulb is
installed properly and replace the bulb socket if necessary.
Perform BODY VERIFICATION TEST.
No >> Repair the Right Front Lamp Assembly ground circuit for
an open.
Perform BODY VERIFICATION TEST.
- EXTERIOR/HEAD-
ZH