Chrysler 2005 Crossfire SRT6 Service Manual page 1004

8J - 50 INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS
*HIGH BEAM INDICATOR INOPERATIVE (CONTINUED)
INDICATOR CIRCUIT OPEN
INDICATOR LAMP
INSTRUMENT CLUSTER
For a complete Instrument Cluster Circuit Diagram, (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
HIGH BEAM INDICATOR LAMP
Turn the ignition off.
Disconnect the Instrument Cluster C1 harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
Turn the High Beams on.
Measure the voltage of the High Beam Indicator Lamp circuit at the
Instrument Cluster C1 harness connector.
Is the voltage above 10 volts?
Yes >> Check the High Beam Indicator Lamp. If the lamp is OK,
Replace the Instrument Cluster.(Refer to 8 - ELECTRICAL/
INSTRUMENT CLUSTER - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
POSSIBLE CAUSES
ZH