Chrysler 2005 Crossfire SRT6 Service Manual page 1519

ZH
CAN B BUS (-) CIRCUIT FAILURE (CONTINUED)
2.
MEASURE THE VOLTAGE OF THE CAN B BUS (-) CIRCUIT
Turn the ignition on.
Measure the voltage of the CAN B Bus (-) circuit at the CLP/SSM har-
ness connector.
Is voltage present?
Yes >> Repair the CAN B Bus (-) circuit for a short to voltage.
Perform VTSS VERIFICATION TEST.
No >> Go to 3
3.
MEASURE THE RESISTANCE OF THE CAN B BUS (-) CIRCUIT
Turn the ignition off.
Measure the resistance between ground and the CAN B Bus (-) circuit
at the CLP/SSM harness connector.
Is the resistance below 10K ohms?
Yes >> Repair the CAN B Bus (-) circuit for a short to ground.
Perform VTSS VERIFICATION TEST.
No >> Replace the Central Locking Pump/Security System Mod-
ule. (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECU-
RITY/SENTRY
REMOVAL).
Perform VTSS VERIFICATION TEST.
VEHICLE THEFT SECURITY - ELECTRICAL DIAGNOSTICS 8Q - 13
KEY REMOTE ENTRY MODULE -