Chrysler 2005 Crossfire SRT6 Service Manual page 1471

ZH
Note: The carpet is firmly molded, and will need to
be propped up while servicing the impact sensor.
14. Disconnect the side impact sensor harness con-
nector.
CAUTION: Use caution when disconnecting the
squib connector. Do not pry on the connector
insulator to disengage the connector from the side
impact sensor. Improper removal of the connector
can result in damage to the airbag circuits or con-
nector insulator.
15. Remove the two bolts attaching the side impact
sensor (1) to the body cross brace.
16. Remove the side impact sensor from the vehicle.
REMOVAL – RIGHT SIDE
1. Before attempting any service procedures refer to
the warnings in the beginning of this section. (Refer
to 8 - ELECTRICAL/RESTRAINTS - WARNING).
2. Remove the door sill plate.
Note: Pull straight up on the sill plate to release it
from the retaining clips.
RESTRAINTS - SERVICE INFORMATION 8O - 115