Chrysler 2005 Crossfire SRT6 Service Manual page 1114

8L - 48 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*LEFT STOP LAMP INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT OPEN
GROUND CIRCUIT OPEN
LEFT TAIL/STOP LAMP BULB
For a complete Exterior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR -
SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE LEFT TAIL/STOP LAMP BULB
Note: If all stop lamps are inoperative, inspect Fuse 2 located in the Illumination Control Module/IP Fuse
Block. If the fuse is open, repair the cause of the open fuse before continuing.
Turn the ignition off.
Remove the Left Tail/Stop Lamp bulb and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the Left Tail/Stop Lamp bulb. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/TAIL
LAMP UNIT - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE FUSED B(+) CIRCUIT RESISTANCE
Disconnect the Left Rear Lamp Assembly harness connector.
Disconnect the Illumination Control Module harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between the Left Rear Lamp Assembly har-
ness connector and the Illumination Control Module harness connec-
tor.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open between the Left
Rear Lamp Assembly and the Illumination Control Module.
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH