Chrysler 2005 Crossfire SRT6 Service Manual page 1318

8N - 88 POWER SEATS - ELECTRICAL DIAGNOSTICS
*DRIVER POWER SEAT REAR RISER MOTOR INOPERATIVE (CONTINUED)
DRIVER POWER SEAT FRONT RISER MOTOR
DRIVER POWER SEAT SWITCH
For a complete Power Seats circuit diagram, (Refer to 8 - ELECTRICAL/POWER SEATS - SCHEMATICS AND DIA-
GRAMS).
Diagnostic Test
1.
TEST THE DRIVER POWER SEAT REAR RISER MOTOR
Turn the ignition off.
Disconnect the Driver Power Seat Rear Riser Motor harness connec-
tor.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire from B(+) to one cavity of the Driver Power
Seat Rear Riser Motor connector motor side).
Connect a second jumper wire from ground to the other cavity of the
Driver Power Seat Rear Riser Motor connector (motor side).
Note seat movement, if no seat rear riser movement is noted, reverse
the jumper wires at the Rear Riser Motor connector.
Did the Driver Seat Rear Riser move up or down?
Yes >> Replace the Driver Power Seat Switch. (Refer to 8 -
ELECTRICAL/POWER SEATS/DRIVER SEAT SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Replace the Driver Power Seat Rear Riser Motor. (Refer to 8 - ELECTRICAL/POWER SEATS/REAR
RISER MOTOR - REMOVAL).
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH