Chrysler 2005 Crossfire SRT6 Service Manual page 1414

8O - 58 RESTRAINTS - ELECTRICAL DIAGNOSTICS
PASSENGER SEAT BELT SWITCH CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: The Occupant Restraint Controller (ORC) monitors the Passenger Seat Belt Switch Sense
circuit anytime the ignition is on.
• Set Condition: The DTC will set if the ORC detects a communication fault between the ORC and the Passen-
ger Seat Belt Switch.
PASSENGER SEAT BELT SWITCH SENSE CIRCUIT SHORTED
PASSENGER SEAT BELT SWITCH SENSE CIRCUIT OPEN
PASSENGER SEAT BELT SWITCH
OCCUPANT RESTRAINT CONTROLLER
For a complete Restraints System Circuit Diagram, (Refer to 8 - ELECTRICAL/RESTRAINTS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
READ DTCs WITH THE DRB III
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
Note: Ensure the battery is fully charged.
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Passenger Seat Belt Switch connector.
Note: Check connectors - Clean/repair as necessary.
Connect a 100 jumper wire at the Passenger Seat Belt Switch con-
nector.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
With the DRB III , read the DTCs.
Does the DRB III display a Passenger Seat Belt Switch DTC?
Yes >> Go to 2
No >> Replace the Passenger Seat Belt Switch. (Refer to 8 -
ELECTRICAL/RESTRAINTS/SEAT BELT & RETRACTOR - REMOVAL).
Perform AIRBAG VERIFICATION TEST.
POSSIBLE CAUSES
ZH