Chrysler 2005 Crossfire SRT6 Service Manual page 1240

8N - 10 POWER LOCKS - ELECTRICAL DIAGNOSTICS
BODY CONTROL MODULE INTERNAL FAILURE (CONTINUED)
3.
MEASURE THE VOLTAGE OF THE BCM POWER CIRCUIT
Measure the voltage of the Fused B(+) circuit (cavity 4) at the BCM C4
harness connector.
Is the voltage above 10 volts?
Yes >> Replace the Body Control Module. (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the Fused B(+) circuit for an open.
Perform BODY VERIFICATION TEST.
ZH