Chrysler 2005 Crossfire SRT6 Service Manual page 1205

ZH
*ASH RECEIVER LAMP INOPERATIVE (CONTINUED)
3.
MEASURE ASH RECEIVER LAMP VOLTAGE
Connect the Illumination Control Module harness connector.
Turn the ignition on.
Turn the parking lamps on.
Measure the voltage between the Ash Receiver Lamp harness con-
nector cavity 2 and ground.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Replace the Illumination Control Module. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
LAMP SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
4.
MEASURE ASH RECEIVER LAMP GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Turn the parking lamps off.
Measure the resistance between the Ash Receiver Lamp harness con-
nector cavity 1 and ground.
Is the resistance below 5.0 ohms?
Yes >> Ensure that the Ash Receiver Lamp bulb is installed prop-
erly and replace the bulb socket if necessary.
Perform BODY VERIFICATION TEST.
No >> Repair the Ash Receiver Lamp ground circuit for an open.
Perform BODY VERIFICATION TEST.
LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS 8L - 139
- EXTERIOR/HEAD-