Chrysler 2005 Crossfire SRT6 Service Manual page 1204

8L - 138 LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS
*ASH RECEIVER LAMP INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT OPEN
GROUND CIRCUIT OPEN
ASH RECEIVER LAMP BULB
For a complete Interior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - INTERIOR - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE ASH RECEIVER LAMP BULB
Note: If any BCM DTCs are set, diagnose them first before continuing.
Note: Inspect Fuse 11 located in the Illumination Control Module/IP Fuse Block. If the fuse is open, repair
the cause of the open fuse before continuing.
Turn the ignition off.
Remove the Ash Receiver Lamp Bulb and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the Ash Receiver Lamp bulb. (Refer to 23 - BODY/INTERIOR/CENTER CONSOLE -
REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE FUSED B(+) CIRCUIT RESISTANCE
Disconnect the Ash Receiver Lamp harness connector.
Disconnect the Illumination Control Module harness connector.
Note: Check connector - Clean/repair as necessary.
Measure the resistance of the Fused B(+) circuit from the Ash
Receiver Lamp harness connector to the Illumination Control Module
harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open between the Ash
Receiver Lamp and the Illumination Control Module.
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH