Chrysler 2005 Crossfire SRT6 Service Manual page 1361

ZH
DRIVER AIRBAG SQUIB CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: Ignition on. The Occupant Restraint Controller (ORC) monitors the resistance of the Driver
Squib circuits.
• Set Condition: The Occupant Restraint Controller (ORC) has detected abnormally high voltage, low resistance,
high resistance or an open circuit on one or both of the Driver Squib circuits.
DRIVER SQUIB CIRCUIT(S) OPEN
DRIVER SQUIB CIRCUIT(S) SHORT TO VOLTAGE
DRIVER SQUIB CIRCUIT(S) SHORT TO GROUND
DRIVER SQUIB CIRCUITS SHORT TO EACH OTHER
DRIVER AIRBAG SQUIB
OCCUPANT RESTRAINT CONTROLLER
For a complete Restraints System Circuit Diagram, (Refer to 8 - ELECTRICAL/RESTRAINTS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
WITH THE DRB III , READ DTCs
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
Note: Ensure the battery is fully charged.
Turn the ignition on.
With the DRB III , select ACTIVE or STORED DTCs.
Is the DTC ACTIVE?
Yes >> Go to 2
No >> Go to 11
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 5
POSSIBLE CAUSES