Chrysler 2005 Crossfire SRT6 Service Manual page 1630

8R - 60 WIPERS/WASHERS - SERVICE INFORMATION
Note: Insure that the wiper motor harness and its
rubber grommets are seated and routed properly
to avoid interference with moving parts.
5. Install the wiper motor harness and rubber grom-
met (2) into the cowl ledge (3).
6. Install the wiper motor harness and rubber grom-
met (1) into the control module box (4).
7. Connect the wiper motor harness connector (2) to
the Body Control Module (BCM) (3) and slide the
locking tab fully over the connector (2).
8. Install the control module box cover (1).
9. Install the cowl grille. (Refer to 23 - BODY/EXTE-
RIOR/COWL GRILLE - INSTALLATION).
10. Install the wiper arms. (Refer to 8 - ELECTRICAL/
WIPERS/WASHERS/WIPER ARMS - INSTALLA-
TION).
11. Connect the negative battery cable.
ZH