Chrysler 2005 Crossfire SRT6 Service Manual page 1489

ZH
REMOVAL
WARNING: DURING AND FOLLOWING ANY SEAT BELT OR CHILD RESTRAINT ANCHOR SERVICE, CARE-
FULLY INSPECT ALL SEAT BELTS, BUCKLES, MOUNTING HARDWARE, RETRACTORS, TETHER STRAPS,
AND ANCHORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY BELT THAT IS
CUT, FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS.
REPLACE ANY BELT THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY
BELT THAT HAS A BENT OR DAMAGED LATCH PLATE OR ANCHOR PLATE. REPLACE ANY CHILD
RESTRAINT ANCHOR OR THE UNIT TO WHICH THE ANCHOR IS INTEGRAL THAT HAS BEEN BENT OR
DAMAGED. NEVER ATTEMPT TO REPAIR A SEAT BELT OR CHILD RESTRAINT COMPONENT. ALWAYS
REPLACE DAMAGED OR FAULTY SEAT BELT AND CHILD RESTRAINT COMPONENTS WITH THE CORRECT,
NEW AND UNUSED REPLACEMENT PARTS LISTED IN THE DAIMLERCHRYSLER MOPAR PARTS CATALOG.
WARNING: NEVER DISASSEMBLE THE SEAT
BELT TENSIONERS.
CAUTION: Never attempt to eliminate noises by
lubricating with oil or grease.
1. Before attempting any service procedure refer to
the warnings in this section. (Refer to 8 - ELEC-
TRICAL/RESTRAINTS - WARNING).
2. Move the seat to the full forward position.
3. Disconnect the negative battery cable (2). Wait two
minutes for the system capacitor to discharge
before further service.
4. Remove the plastic bolt cover from the seat.
5. Remove the bolt (1) on the belt end attaching it to
the seat.
RESTRAINTS - SERVICE INFORMATION 8O - 133