Chrysler 2005 Crossfire SRT6 Service Manual page 1201

ZH
*GLOVE BOX LAMP INOPERATIVE (CONTINUED)
FUSED IGNITION SWITCH OUTPUT CIRCUIT OPEN
GROUND CIRCUIT OPEN
GLOVE BOX LAMP BULB
For a complete Interior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - INTERIOR - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE GLOVE BOX LAMP BULB
Note: If any BCM DTCs are set, diagnose them first before continuing.
Note: Inspect Fuse 31 located in the Underhood Accessory Fuse Block. If the fuse is open, repair the cause
of the open fuse before continuing.
Turn the ignition off.
Remove the Glove Box Lamp Bulb and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the Glove Box Lamp bulb. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - INTERIOR/GLOVE
BOX LAMP - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE GLOVE BOX LAMP VOLTAGE
Disconnect the Glove Box Lamp harness connector.
Note: Check connector - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage between ground and the Glove Box Lamp har-
ness connector cavity 2.
Is the voltage above 10 volts?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open.
Perform BODY VERIFICATION TEST.
LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS 8L - 135
POSSIBLE CAUSES