Chrysler 2005 Crossfire SRT6 Service Manual page 1180

8L - 114 LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
4. Clean headlamp lenses.
5. Verify that luggage area is not heavily loaded.
6. Fuel tank should be FULL. Add 2.94 kg (6.5 lbs.) of weight over the fuel tank for each estimated gallon of miss-
ing fuel.
ALIGNMENT SCREEN PREPARATION
1. Position vehicle on a level surface perpendicular to a flat wall 7.62 meters (25 ft.) away from front of headlamp
lens (Note: If necessary, tape a line on the floor 7.62 meters (25 ft.) away from and parallel to the wall).
2. From the base of the wall, measure up 1.27 meters (5 ft.), and tape a line on the wall at the center line of the
vehicle. Sight along the center line of the vehicle (from rear of vehicle forward) to verify accuracy of the line
placement.
3. Rock vehicle side-to-side three times to allow suspension to stabilize.
4. Jounce front suspension three times by pushing downward on front bumper and releasing.
5. Measure the distance from the center of headlamp lens to the ground. Transfer measurement to the alignment
screen (with tape). Use this line for up/down adjustment reference.
6. Measure distance from the center line of the vehicle to the center of each headlamp being aligned. Transfer
measurements to screen (with tape) to each side of vehicle center line.
HEADLAMP ADJUSTMENT
A properly aimed left and right low beam headlamp will project the center of the low beam hot spot on the alignment
screen below the horizontal center line and 152 mm (6 in.) to the right of the headlamp center line. The high beam
headlamps cannot be aligned. The high beam pattern should be correct when the low beams are aligned properly.
To adjust headlamp alignment, rotate alignment screw to achieve the specified low beam hot spot pattern.
ZH