Chrysler 2005 Crossfire SRT6 Service Manual page 1245

ZH
CLP/SSM SYSTEM OVERVOLTAGE (CONTINUED)
When Monitored and Set Condition
• When Monitored: Ignition on. The Central Locking Pump/Security System Module (CLP/SSM) monitors the
Fused B(+) circuit at all times for proper system voltage.
• Set Condition: If the voltage is above 16 volts, the Diagnostic Trouble Code (DTC) is set.
CHARGING SYSTEM
GROUND CIRCUIT OPEN
CENTRAL LOCKING PUMP/SECURITY SYSTEM MODULE INTERNAL FAILURE
For a complete Power Locks Circuit Diagram, (Refer to 8 - ELECTRICAL/POWER LOCKS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
WITH THE DRB III , READ DTCs
Turn the ignition on.
With the DRBIII , read and record the Central Locking Pump/Security
System Module DTCs.
With the DRB III , erase the Central Locking Pump/Security System
Module DTCs.
Start the engine.
With the DRB III , read DTCs.
Does the DRB III display a System Overvoltage DTC?
Yes >> Go To 2
No >> Go To 4
2.
MEASURE THE BATTERY VOLTAGE
Turn the ignition off.
Disconnect the CLP/SSM harness connector.
Note: Check connectors - Clean/repair as necessary.
Start the engine.
Raise the engine speed above 1800 RPM.
Measure the battery voltage.
Is the voltage above 16 volts?
Yes >> Refer to the appropriate service information for charging
system testing and repair.
Perform BODY VERIFICATION TEST.
No >> Go To 3
POWER LOCKS - ELECTRICAL DIAGNOSTICS 8N - 15
POSSIBLE CAUSES