Table of Contents
Advertisement
ZH
WIPER MOTOR
STANDARD PROCEDURE
REPLACEMENT WIPER MOTOR SYNCHRONIZATION
Note: Insure the multifunction switch is in the OFF
position before attempting this procedure.
1. Connect the replacement wiper motor harness con-
nector (1) to the Body Control Module (BCM) (2).
2. Connect the battery negative cable.
CAUTION: Be sure to keep the wiper motor clear
from surrounding wiper system linkage and unse-
cured harness connectors.
3. Hold the wiper motor in one hand.
4. Turn the ignition switch to the ON/RUN position.
5. Rotate the multifunction switch to the low position.
6. Rotate the multifunction switch back to the OFF
position and wait until the wiper motor stops.
7. Turn the ignition switch to the OFF/LOCK position.
8. Disconnect the negative battery cable.
9. Disconnect the wiper motor harness connector
from the BCM.
10. The new wiper motor should now be in the park
position (1) and synchronized for wiper motor
crank installation.
REMOVAL
WARNING: WINDSHIELD WIPER MECHANISM CAN PINCH, CRUSH, OR IN EXTREME CASES, EVEN SEVER
EXTREMITIES. ALWAYS REMOVE IGNITION KEY WHEN WORKING ON WINDSHIELD WIPER MECHANISM.
WIPERS/WASHERS - SERVICE INFORMATION 8R - 61
Advertisement
Chapters
Table of Contents
