Chrysler 2005 Crossfire SRT6 Service Manual page 1284

8N - 54 POWER MIRRORS - ELECTRICAL DIAGNOSTICS
*LEFT POWER MIRROR INOPERATIVE (CONTINUED)
3.
MEASURE LEFT POWER MIRROR HORIZONTAL MOTOR CIRCUIT RESISTANCE
Turn the ignition off.
Disconnect all jumper wires.
Disconnect the Left Power Mirror pigtail harness connector.
Note: The Power Mirror pigtail harness connector can be
accessed by removing the small square access panel located at
the top front corner of the door panel.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 4 and cavity 5 of the Left
Power Mirror pigtail harness connector.
Measure the resistance between cavity 3 and cavity 7 of the Power
Mirror Switch harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Left Power Mirror. (Refer to 8 - ELECTRICAL/
POWER MIRRORS/SIDEVIEW MIRROR - REMOVAL).
No >> Repair the Left Power Mirror Horizontal Motor circuit for an
open.
Perform BODY VERIFICATION TEST.
4.
MEASURE LEFT POWER MIRROR VERTICAL MOTOR CIRCUIT RESISTANCE
Turn the ignition off.
Disconnect all jumper wires.
Disconnect the Left Power Mirror pigtail harness connector.
Note: The Power Mirror pigtail harness connector can be
accessed by removing the small square access panel located at
the top front corner of the door panel.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 6 and cavity 5 of the Left
Power Mirror pigtail harness connector.
Measure the resistance between cavity 3 and cavity 5 of the Power
Mirror Switch harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Left Power Mirror. (Refer to 8 - ELECTRICAL/
POWER MIRRORS/SIDEVIEW MIRROR - REMOVAL).
No >> Repair the Left Power Mirror Vertical Motor circuit for an
open.
Perform BODY VERIFICATION TEST.
ZH