Chrysler 2005 Crossfire SRT6 Service Manual page 1115

ZH
*LEFT STOP LAMP INOPERATIVE (CONTINUED)
3.
MEASURE LEFT TAIL/STOP LAMP VOLTAGE
Connect the Illumination Control Module harness connector.
Depress the brake pedal.
Measure the voltage between the Left Rear Lamp Assembly harness
connector cavity 4 and ground.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Replace the Illumination Control Module.
Perform BODY VERIFICATION TEST.
4.
MEASURE LEFT TAIL/STOP LAMP GROUND CIRCUIT RESISTANCE
Release the brake pedal.
Measure the resistance between the Left Rear Lamp Assembly har-
ness connector and ground.
Is the resistance below 5.0 ohms?
Yes >> Ensure that the Left Tail/Stop Lamp bulb is installed prop-
erly and replace the bulb socket if necessary.
Perform BODY VERIFICATION TEST.
No >> Repair the Left Rear Lamp Assembly ground circuit fro an
open.
Perform BODY VERIFICATION TEST.
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS 8L - 49