Chrysler 2005 Crossfire SRT6 Service Manual page 1410

8O - 54 RESTRAINTS - ELECTRICAL DIAGNOSTICS
DRIVER SEAT BELT SWITCH CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: The Occupant Restraint Controller (ORC) monitors the Driver Seat Belt Switch Sense circuit
anytime the ignition is on.
• Set Condition: The DTC will set if the ORC detects a communication fault between the ORC and the Driver
Seat Belt Switch.
DRIVER SEAT BELT SWITCH SENSE CIRCUIT SHORTED
DRIVER SEAT BELT SWITCH SENSE CIRCUIT OPEN
DRIVER SEAT BELT SWITCH
OCCUPANT RESTRAINT CONTROLLER
For a complete Restraints System Circuit Diagram, (Refer to 8 - ELECTRICAL/RESTRAINTS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
READ DTCs WITH THE DRB III
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
Note: Ensure the battery is fully charged.
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Driver Seat Belt Switch harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a 100 jumper wire at the Driver Seat Belt Switch harness
connector.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
With the DRB III , read the DTCs.
Does the DRB III display a Driver Seat Belt Switch DTC?
Yes >> Go to 2
No >> Replace the Driver Seat Belt Switch. (Refer to 8 - ELEC-
TRICAL/RESTRAINTS/SEAT BELT & RETRACTOR - REMOVAL).
Perform AIRBAG VERIFICATION TEST.
POSSIBLE CAUSES
ZH