Chrysler 2005 Crossfire SRT6 Service Manual page 1411

ZH
DRIVER SEAT BELT SWITCH CIRCUIT (CONTINUED)
2.
MEASURE THE VOLTAGE OF THE DRIVER SEAT BELT SWITCH SENSE CIRCUIT
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the ORC connector.
Note: Check connectors - Clean/repair as necessary.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
Measure the voltage of the Driver Seat Belt Switch Sense circuit at the
Driver Seat Belt Switch harness connector.
Is voltage present?
Yes >> Repair the Driver Seat Belt Switch Sense circuit for a short
to voltage.
Perform AIRBAG VERIFICATION TEST.
No >> Go to 3
3.
MEASURE THE RESISTANCE OF THE DRIVER SEAT BELT SWITCH SENSE CIRCUIT
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
Measure the resistance of the Driver Seat Belt Switch Sense circuit
between the ORC and the Driver Seat Belt Switch harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 4
No >> Repair the Driver Seat Belt Switch Sense circuit for an
open.
Perform AIRBAG VERIFICATION TEST.
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 55