Chrysler 2005 Crossfire SRT6 Service Manual page 749

ZH
*NO RESPONSE FROM SHIFT LEVER ASSEMBLY (CONTINUED)
3.
TRACTION SYSTEM RELAY OUTPUT CIRCUIT OPEN
Turn the ignition off.
Disconnect the SLA harness connector.
Note: Check connector — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Traction System Relay Output circuit at the
SLA harness connector.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Repair the Traction System Relay Output circuit for an
open.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
4.
FUSED IGNITION SWITCH OUTPUT CIRCUIT OPEN
With the ignition on.
Measure the voltage of the Fused Ignition Switch Output circuit at the
SLA harness connector.
Is the voltage above 10 volts?
Yes >> Go to 5
No >> Repair the Fused Ignition Switch Output circuit for an
open.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
5.
GROUND CIRCUIT OPEN
Turn the ignition off.
Measure the resistance of the Ground circuit from the SLA harness
connector to ground.
Is the resistance below 5.0 ohms?
Yes >> Go to 6
No >> Repair the Ground circuit for an open.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
ELECTRONIC CONTROL MODULES - ELECTRICAL DIAGNOSTICS 8E - 47