Chrysler 2005 Crossfire SRT6 Service Manual page 890

8G - 30 HEATED SEATS - ELECTRICAL DIAGNOSTICS
*LEFT HEATED SEAT INOPERATIVE (CONTINUED)
LEFT SEAT BACK/CUSHION HEATER ELEMENT
LEFT HEATED SEAT OUTPUT CIRCUIT OPEN
LEFT HEATED SEAT GROUND CIRCUIT OPEN
HEATED SEAT MODULE
For a complete Heated Seats Circuit Diagram (Refer to 8 - ELECTRICAL/HEATED SEATS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
TEST THE LEFT HEATED SEAT
Turn the ignition off.
Disconnect the Heated Seat Module harness connector.
Note: Check connector - Clean/repair as necessary.
Connect a fused jumper wire from B(+) to cavity 3 (LHD) of the
Heated Seat Module harness connector.
With the jumper wire connected, does the Left Heated Seat
warm up?
Yes >> Replace the Heated Seat Module.(Refer to 8 - ELECTRI-
CAL/HEATED
REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
POSSIBLE CAUSES
SEATS/HEATED SEAT MODULE -
ZH