Chrysler 2005 Crossfire SRT6 Service Manual page 1549

ZH
REMOTE KEYLESS ENTRY RELAY CONTROL CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: Continuous.
• Set Condition: The Sentry Key Remote Entry Module (SKREEM) reports a short to power, ground, or an open
circuit failure on the Remote Keyless Entry Relay Control circuit.
REMOTE KEYLESS ENTRY RELAY CONTROL CIRCUIT SHORTED TO VOLTAGE
REMOTE KEYLESS ENTRY RELAY CONTROL CIRCUIT SHORTED TO GROUND
REMOTE KEYLESS ENTRY RELAY CONTROL CIRCUIT OPEN
REMOTE KEYLESS ENTRY RELAY
For a complete Sentry Key Remote Entry (SKREEM) Circuit Diagram, (Refer to 8 - ELECTRICAL/VEHICLE THEFT
SECURITY - SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
MEASURE THE RESISTANCE OF THE REMOTE KEYLESS ENTRY RELAY CONTROL CIRCUIT
Turn the ignition off.
Disconnect the SKREEM harness connector.
Remove the Remote Keyless Entry Relay.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Remote Keyless Entry Relay Control
circuit from the SKREEM harness connector to the Remote Keyless
Entry Relay harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 2
No >> Repair the Remote Keyless Entry Relay Control circuit for
an open.
Perform SENTRY KEY VERIFICATION TEST.
VEHICLE THEFT SECURITY - ELECTRICAL DIAGNOSTICS 8Q - 43
POSSIBLE CAUSES