Chrysler 2005 Crossfire SRT6 Service Manual page 1424

8O - 68 RESTRAINTS - ELECTRICAL DIAGNOSTICS
RIGHT SIDE IMPACT SENSOR SIGNAL CIRCUIT (CONTINUED)
4.
MEASURE THE VOLTAGE OF THE RIGHT SIDE IMPACT SENSOR SIGNAL CIRCUIT
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
Measure the voltage of the Right Side Impact Sensor Signal circuit at
the Right Side Impact Sensor harness connector.
Is voltage present?
Yes >> Repair the Right Side Impact Sensor Signal circuit for a
short to voltage.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 5
5.
MEASURE THE RIGHT SIDE IMPACT SENSOR GROUND CIRCUIT RESISTANCE
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Measure the resistance between ground and the Right Side Impact
Sensor Ground circuit.
Is the resistance below 1.0 ohm?
Yes >> Replace the Right Side Impact Sensor. (Refer to 8 -
ELECTRICAL/RESTRAINTS/IMPACT
REMOVAL).
Perform AIRBAG VERIFICATION TEST.
No >> Repair the open Right Side Impact Sensor Ground circuit.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
SENSOR -
ZH