Chrysler 2005 Crossfire SRT6 Service Manual page 894

8G - 34 HEATED SEATS - ELECTRICAL DIAGNOSTICS
*RIGHT HEATED SEAT INOPERATIVE (CONTINUED)
2.
MEASURE RIGHT HEATED SEAT OUTPUT CIRCUIT RESISTANCE
Disconnect the Right Heated Seat Back/Heated Seat Cushion harness
connector.
Note: Check connector - Clean/repair as necessary.
Measure the resistance of the Right Heated Seat Output circuit
between the Heated Seat Module harness connector and the Right
Heated Seat Back/Heated Seat Cushion harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Right Heated Seat Output circuit for an open.
Perform BODY VERIFICATION TEST.
3.
MEASURE RIGHT HEATED SEAT GROUND CIRCUIT RESISTANCE
Measure the resistance between ground and the Right Heated Seat
Ground circuit.
Is the resistance below 5.0 ohms?
Yes >> Replace the Right Heated Seat Back/Heated Seat Cushion
Element. (Refer to 8 - ELECTRICAL/HEATED SEATS/
HEATED SEAT BACK ELEMENT - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the Right Heated Seat Ground circuit for an open.
Perform BODY VERIFICATION TEST.
ZH