Chrysler 2005 Crossfire SRT6 Service Manual page 1406

8O - 50 RESTRAINTS - ELECTRICAL DIAGNOSTICS
PASSENGER AIRBAG ON/OFF SWITCH SIGNAL CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the ignition on. The Occupant Restraint Controller (ORC) monitors the status of the
Passenger Airbag On/Off Switch Signal circuit.
• Set Condition: The DTC will set if a communication fault is detected between the ORC and the Passenger
Seat Occupant Simulator.
FUSED B(+) CIRCUIT OPEN
PASSENGER AIRBAG ON/OFF SWITCH SIGNAL CIRCUIT OPEN
PASSENGER AIRBAG ON/OFF SWITCH SIGNAL CIRCUIT SHORT TO VOLTAGE
PASSENGER AIRBAG ON/OFF SWITCH SIGNAL CIRCUIT SHORT TO GROUND
PASSENGER SEAT OCCUPANT SIMULATOR
OCCUPANT RESTRAINT CONTROLLER
For a complete Restraints System Circuit Diagram, (Refer to 8 - ELECTRICAL/RESTRAINTS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
MEASURE FUSED B(+) CIRCUIT VOLTAGE
Note: Inspect Fuse 2 located in the Underhood Accessory Fuse
Block. If the fuse is open, repair the cause of the open first
before continuing.
Note: The Passenger Seat Occupant Simulator is located behind
the passenger footwell near the Power Amplifier.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Passenger Seat Occupant Simulator harness connec-
tor.
Note: Check connector - Clean/repair as necessary.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
Measure the voltage of the Fused B(+) circuit at the Passenger Seat Occupant Simulator harness connector.
Is the voltage above 10 volts?
Yes >> Go to 2
No >> Repair the Passenger Seat Occupant Simulator Fused B(+) circuit.
Perform AIRBAG VERIFICATION TEST.
POSSIBLE CAUSES
ZH