Chrysler 2005 Crossfire SRT6 Service Manual page 1195

ZH
DOME LAMP CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the ignition on.
• Set Condition: The Body Control Module (BCM) reports a short to power, ground, or an open on the Dome
Lamp circuit.
DOME LAMP CIRCUIT SHORT TO VOLTAGE
DOME LAMP CIRCUIT SHORT TO GROUND
DOME LAMP CIRCUIT OPEN
BODY CONTROL MODULE INTERNAL FAILURE
For a complete Interior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - INTERIOR - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
MEASURE THE RESISTANCE OF THE DOME LAMP CIRCUIT
Turn the ignition off.
Disconnect the BCM harness connector.
Disconnect the Dome Lamp harness connector.
Note: Check connector - Clean/repair as necessary.
Measure the resistance of the Dome Lamp circuit between the BCM
harness connector and the Dome Lamp harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 2
No >> Repair the Dome Lamp circuit for an open.
Perform BODY VERIFICATION TEST.
LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS 8L - 129
POSSIBLE CAUSES