Chrysler 2005 Crossfire SRT6 Service Manual page 1404

8O - 48 RESTRAINTS - ELECTRICAL DIAGNOSTICS
AIRBAG WARNING INDICATOR CIRCUIT (CONTINUED)
3.
MEASURE THE VOLTAGE AT THE ORC
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the ORC harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between the terminals in the Instrument Cluster
harness connector.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
Measure the voltage of the Airbag Warning Indicator Driver circuit at
the ORC harness connector.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Repair the Airbag Warning Indicator Driver circuit for an
open.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
4.
MEASURE THE VOLTAGE AT THE ORC
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Reconnect the Instrument Cluster harness connector.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
Connect a jumper wire to ground at the ORC harness connector.
Did the Airbag Warning Indicator Light illuminate?
Yes >> Replace the Occupant Restraint Controller. (Refer to 8 -
ELECTRICAL/RESTRAINTS/OCCUPANT
CONTROLLER - REMOVAL).
WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS
DROPPED AT ANY TIME, IT MUST BE REPLACED.
Perform AIRBAG VERIFICATION TEST.
No >> Replace the Instrument Cluster. (Refer to 8 - ELECTRI-
CAL/INSTRUMENT CLUSTER - REMOVAL).
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the ignition must be turned off and the battery
must be disconnected.
RESTRAINT
ZH