Chrysler 2005 Crossfire SRT6 Service Manual page 1133

ZH
*RIGHT REAR TURN LAMP INOPERATIVE (CONTINUED)
3.
MEASURE RIGHT REAR TURN LAMP VOLTAGE
Connect the Multi-Function Switch harness connector.
Turn the ignition on.
Turn the right turn signal on.
Measure the voltage between the Right Rear Lamp Assembly harness
connector cavity 3 and ground.
Is voltage present?
Yes >> Go to 4
No >> Replace the Multi-Function Switch. (Refer to 8 - ELECTRI-
CAL/LAMPS/LIGHTING - EXTERIOR/MULTI-FUNCTION
SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
4.
MEASURE RIGHT REAR TURN LAMP GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Turn the right turn signal off.
Measure the resistance between the Right Rear Lamp Assembly har-
ness connector cavity 1 and ground.
Is the resistance below 5.0 ohms?
Yes >> Ensure that the Right Rear Turn Lamp bulb is installed
properly and replace the bulb socket if necessary.
Perform BODY VERIFICATION TEST.
No >> Repair the Right Rear Lamp Assembly ground circuit for
an open.
Perform BODY VERIFICATION TEST.
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS 8L - 67