Chrysler 2005 Crossfire SRT6 Service Manual page 1374

8O - 18 RESTRAINTS - ELECTRICAL DIAGNOSTICS
PASSENGER SEAT BELT TENSIONER SQUIB CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: Ignition on. The Occupant Restraint Controller (ORC) monitors the resistance of the Passen-
ger Seat Belt Squib circuits.
• Set Condition: The Occupant Restraint Controller (ORC) has detected abnormally high voltage, low resistance,
high resistance or an open circuit on one or both of the Passenger Seat Belt Squib circuits.
PASSENGER SEAT BELT SQUIB CIRCUIT(S) OPEN
PASSENGER SEAT BELT SQUIB CIRCUIT(S) SHORT TO VOLTAGE
PASSENGER SEAT BELT SQUIB CIRCUIT(S) SHORT TO GROUND
PASSENGER SEAT BELT SQUIB CIRCUITS SHORT TO EACH OTHER
PASSENGER SEAT BELT TENSIONER SQUIB
OCCUPANT RESTRAINT CONTROLLER
For a complete Restraints System Circuit Diagram, (Refer to 8 - ELECTRICAL/RESTRAINTS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
WITH THE DRB III , READ DTCs
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
Note: Ensure the battery is fully charged.
Turn the ignition on.
With the DRB III , select ACTIVE or STORED DTCs.
Is the DTC ACTIVE?
Yes >> Go to 2
No >> Go to 10
2.
WITH THE DRB III , READ ACTIVE DTCs
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Passenger Seat Belt Tensioner connector.
Note: Check connectors - Clean/repair as necessary.
Connect the appropriate Load Tool to the Passenger Seat Belt Ten-
sioner Squib connector.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
With the DRB III , read the active DTCs.
Does the DRB III display an active Passenger Seat Belt Ten-
sioner Squib DTC?
Yes >> Go to 3
No >> Replace the Passenger Seat Belt Tensioner. (Refer to 8 - ELECTRICAL/RESTRAINTS/SEAT BELT &
RETRACTOR - REMOVAL).
Perform AIRBAG VERIFICATION TEST.
POSSIBLE CAUSES
ZH