Chrysler 2005 Crossfire SRT6 Service Manual page 1268

8N - 38 POWER LOCKS - SERVICE INFORMATION
2. Align the outer gang of switches over the power
lock switch and press together until the locking
tabs engage fully.
3. Connect the power lock switch harness connectors.
4. Install the trim panel on the center console. (Refer
to 23 - BODY/INTERIOR/CENTER CONSOLE -
INSTALLATION).
5. Connect the negative battery cable.
DOOR LATCH ASSEMBLY
REMOVAL
WARNING: REFER TO RESTRAINTS BEFORE ATTEMPTING ANY DOOR, SEAT, STEERING WHEEL, STEER-
ING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE
PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PER-
SONAL INJURY. (Refer to 8 - ELECTRICAL/RESTRAINTS - WARNING).
1. Remove the door interior trim panel. (Refer to 23 -
BODY/DOOR - FRONT/TRIM PANEL - REMOVAL).
2. Remove the door lock cylinder. (Refer to 23 -
BODY/DOOR - FRONT/LOCK
REMOVAL).
3. Gently peel back the door watershield (1) enough
to expose the door latch assembly installation
opening.
CYLINDER -
ZH