Chrysler 2005 Crossfire SRT6 Service Manual page 1108

8L - 42 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*RIGHT REAR SIDE MARKER LAMP INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT OPEN
GROUND CIRCUIT OPEN
RIGHT REAR SIDE MARKER LAMP BULB
For a complete Exterior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR -
SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE RIGHT REAR SIDE MARKER LAMP BULB
Note: If the right front side marker lamp, the right park lamp, the right rear side marker lamp, and the right
tail lamp are inoperative, inspect Fuse 7 located in the Illumination Control Module/IP Fuse Block. If the fuse
is open, repair the cause of the open fuse before continuing.
Turn the ignition off.
Remove the Right Rear Side Marker Lamp bulb and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the Right Rear Side Marker Lamp bulb. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTE-
RIOR/MARKER LAMP - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE FUSED B(+) CIRCUIT RESISTANCE
Disconnect the Right Rear Side Marker Lamp harness connector.
Disconnect the Illumination Control Module harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between the Right Rear Side Marker Lamp
harness connector and the Illumination Control Module harness con-
nector.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open between the
Right Rear Side Marker Lamp and the Illumination Control
Module.
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH