Chrysler 2005 Crossfire SRT6 Service Manual page 1291

ZH
*AUTOMATIC DAY/NIGHT MIRROR INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT OPEN
AUTOMATIC DAY/NIGHT MIRROR GROUND CIRCUIT OPEN
AUTOMATIC DAY/NIGHT MIRROR
For a complete Power Mirrors Circuit Diagram, (Refer to 8 - ELECTRICAL/POWER MIRRORS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
MEASURE AUTOMATIC DAY/NIGHT MIRROR FUSED B(+) CIRCUIT VOLTAGE
Note: Inspect Fuse 7 located in the Underhood Accessory Fuse Block. If the fuse is open, repair the cause
of the open fuse before continuing.
Turn the ignition off.
Disconnect the Automatic Day/Night Mirror harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused B(+) circuit at the Automatic Day/
Night Mirror harness connector.
Is the voltage above 10 volts?
Yes >> Go to 2
No >> Repair the Automatic Day/Night Mirror Fused B(+) circuit
for an open.
Perform BODY VERIFICATION TEST.
2.
MEASURE AUTOMATIC DAY/NIGHT MIRROR GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Measure the resistance between ground and the Automatic Day/Night
Mirror Ground circuit.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Ground circuit for an open.
Perform BODY VERIFICATION TEST.
POWER MIRRORS - ELECTRICAL DIAGNOSTICS 8N - 61
POSSIBLE CAUSES