Chrysler 2005 Crossfire SRT6 Service Manual page 1393

ZH
RIGHT SIDE AIRBAG SQUIB CIRCUIT (CONTINUED)
2.
WITH THE DRB III , READ ACTIVE DTCs
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG
FACE DOWN ON A HARD SURFACE; THE AIRBAG WILL PROPEL
INTO THE AIR IF ACCIDENTALLY DEPLOYED, AND COULD
RESULT IN SERIOUS OR FATAL INJURY.
Disconnect the Right Side airbag.
Note: Check connectors - Clean/repair as necessary.
Connect the appropriate Load Tool to the Right Side Airbag Squib con-
nector.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
With the DRB III , read the active Airbag DTCs.
Does the DRB III display an active Right Side Airbag Squib DTC?
Yes >> Go to 3
No >> Replace the Right Side Airbag. (Refer to 8 - ELECTRICAL/RESTRAINTS/SIDE IMPACT AIRBAG CON-
TROL MOD - REMOVAL).
Perform AIRBAG VERIFICATION TEST.
3.
MEASURE THE RESISTANCE OF THE RIGHT SIDE SQUIB LINE 1 CIRCUIT
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the ORC harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect the appropriate harness adapter to the ORC connector.
Disconnect the Load Tool from the Right Side Airbag Squib connector.
Measure the resistance of the Right Side Squib Line 1 circuit from the
ORC adapter to the Right Side Airbag Squib connector.
Is the resistance below 1.0 ohm?
Yes >> Go to 4
No >> Repair the Right Side Squib Line 1 circuit for an open.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 37