Chrysler 2005 Crossfire SRT6 Service Manual page 1015

ZH
*TELESCOPING WHEEL INDICATOR INOPERATIVE (CONTINUED)
INDICATOR CIRCUIT OPEN
SWITCH MALFUNCTION
INDICATOR LAMP
INSTRUMENT CLUSTER
For a complete Instrument Cluster Circuit Diagram, (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE TELESCOPING WHEEL INDICATOR LAMP
Note: The Telescoping Wheel Indicator circuit is hardwired to the Telescopic Steering Switch. If replacement
is necessary, the Switch and harness are replaced together.
Turn the ignition off.
Remove the Telescoping Wheel Indicator Lamp from the Instrument Cluster and inspect the lamp for an open fila-
ment.
Is the lamp filament open?
Yes >> Replace the Telescoping Wheel Indicator Lamp. (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER -
STANDARD PROCEDURE).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE TELESCOPING WHEEL INDICATOR CIRCUIT RESISTANCE
With the ignition off.
Disconnect the Instrument Cluster C2 harness connector.
Note: Check connectors - Clean/repair as necessary.
With the Telescopic Steering Switch depressed, measure the resis-
tance between ground and the Telescoping Wheel Indicator circuit.
Is the resistance below 5.0 ohms?
Yes >> Replace the Instrument Cluster. (Refer to 8 - ELECTRI-
CAL/INSTRUMENT CLUSTER - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Replace the Telescopic Steering Switch.
Perform BODY VERIFICATION TEST.
INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS 8J - 61
POSSIBLE CAUSES