Chrysler 2005 Crossfire SRT6 Service Manual page 1477

ZH
2. Position the side impact sensor (1) on the body
cross brace.
3. Install the bolts attaching the side impact sensor to
the body cross brace. Tighten the side impact sen-
sor bolts to 12 N·m (106 in. lbs.).
CAUTION: Use caution when connecting the squib
harness connector to the side impact sensor
receptacle. Improper assembly of these connec-
tors can result in damage to the airbag circuits or
connector insulators.
4. Connect the side impact sensor harness connector.
5. Reposition the carpet to the floor.
Note: The carpet is firmly molded, and will need to
be properly seated to the contours of the vehicle
floor.
6. Install the carpet hold down button (1).
7. Install the front seat.
8. Reconnect the power seat harness connectors.
9. Install the seat belt bolt (2). Tighten the seat belt
bolt to 35 N·m (26 ft. lbs.).
10. Install the seat track rear bolts (1). Tighten the
rear bolts to 50 N·m (37 ft. lbs.).
RESTRAINTS - SERVICE INFORMATION 8O - 121