Chrysler 2005 Crossfire SRT6 Service Manual page 1575

ZH
*HEATED WASHER NOZZLES INOPERATIVE (CONTINUED)
FUSED IGNITION OR GROUND CIRCUIT OPEN
THERMOSWITCH
WASHER NOZZLE
For a complete Wipers/Washers Circuit Diagram, (Refer to 8 - ELECTRICAL/WIPERS/WASHERS - SCHEMATICS
AND DIAGRAMS).
Diagnostic Test
1.
TEST POWER SUPPLY AND GROUND CIRCUITS
Note: Inspect Fuse 12 located in the Underhood Accessory Fuse
Block. If the fuse is open, repair the cause of the open fuse
before continuing.
Disconnect the heated washer nozzle harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Connect a test light between cavity 1 and 2 of the washer nozzle har-
ness connector.
Did the test light illuminate?
Yes >> Go to 2
No >> Go to 3
2.
TEST BOTH HEATED NOZZLES
Disconnect the right and left heated nozzle connectors and the nozzle
connector to the thermoswitch.
Measure the resistance across each heated nozzle connector.
Are the resistance values between 80–120 ohms?
Yes >> Replace the thermoswitch.
No >> Replace the faulty heated nozzle. (Refer to 8 - ELECTRI-
CAL/WIPERS/WASHERS/WASHER
REMOVAL).
Perform BODY VERIFICATION TEST.
WIPERS/WASHERS - ELECTRICAL DIAGNOSTICS 8R - 5
POSSIBLE CAUSES
NOZZLE -