Chrysler 2005 Crossfire SRT6 Service Manual page 1648

8W - 01 - 12
DIODE
REMOVAL
1. Disconnect the battery.
2. Locate the diode in the harness, and remove the
protective covering.
3. Remove the diode from the harness, pay attention
to the current flow direction(1).
INSTALLATION
1. Remove the insulation from the wires in the harness. Only remove enough insulation to solder in the new diode.
2. Install the new diode in the harness, making sure current flow is correct. If necessary, refer to the appropriate
wiring diagram for current flow.
3. Solder the connection together using rosin core type solder only. Do not use acid core solder.
4. Tape the diode to the harness using electrical tape. Make sure the diode is completely sealed from the elements.
5. Re-connect the battery and test affected systems.
TERMINAL
REMOVAL
1. Follow steps for removing terminals described in the connector removal section.
2. Cut the wire 6 inches from the back of the connector.
INSTALLATION
1. Select a wire from the terminal repair kit that best matches the color and gage of the wire being repaired.
2. Cut the repair wire to the proper length and remove one–half (1/2) inch of insulation.
3. Splice the repair wire to the wire harness (see wire splicing procedure). (Refer to 8 - ELECTRICAL/WIRING
DIAGRAM INFORMATION/WIRE - STANDARD PROCEDURE).
4. Insert the repaired wire into the connector.
5. Install the connector locking wedge, if required, and reconnect the connector to its mating half/component.
6. Re-tape the wire harness starting at 1–1/2 inches behind the connector and 2 inches past the repair.
7. Connect battery and test all affected systems.
8W-01 WIRING DIAGRAM INFORMATION ZH